Multi-Tech Systems MVP 800 - Manual (Page 2)

Page 2 of 4
MultiVOIP Software Version 3.01C Product Update
If you changed the voice coder, ensure that the same voice coder is used on the voice/fax channel you
are calling; otherwise, you will always get a busy signal.
17. If you selected the FXO interface and are using touchtone dialing, you can set up the DTMF gain (or
output level in decibels - dB) for the higher and lower frequency groups of the DTMF tone pair. Make
your selections in the drop-down lists in the DTMF Gain group.
Note: Only change the DTMF gain under the direction of Multi-Tech Technical Support supervision.
18. The Fax group enables you to send/receive faxes on the selected voice/fax channel. You can set the
maximum baud rate for faxes in the drop-down list in the Fax group.
If you do not plan to send or receive faxes on a given voice/fax channel, you can disable faxes in the
Fax group.
Note: After configuring a given channel, you can copy that channel’s configuration by clicking the
Copy button and everything on the Voice/Fax tab will be copied to the other channel.
The Billing/Security tab displays the parameters for billing options, call authentication, and automatic
disconnection.
19. You can set up billing options for inbound and/or outbound calls by checking them in the Billing
Options group and then entering the charge in cents per number of seconds.
20. Password protection can be enabled for outbound and/or inbound calls on the selected voice/fax
channel. If you enable Call Authentication on inbound and/or outbound calls, you need to enter a
password of up to 14 numeric characters in the Password field.
21. The Automatic Disconnection option limits call duration to the number of seconds entered in the
Disconnect After: (sec) field. The default value of 180 seconds can be changed to any other value up
to 65,535 seconds (approximately 18.2 hours).
Note: After configuring a given channel, you can copy that channel’s configuration to the other channel
by clicking the Copy button. Everything on the Billing/Security tab will be copied to the other channel.
If your country/region is not the default USA, click the Regional tab and proceed to step 22; otherwise,
proceed to step 23 to begin building your phone directory database.