3 transferring a config file, 3 transferring a config file -19 – Motorola Series Switch WS5100 User Manual
Page 63
Switch Information
3-19
3. Select the
Copy this file as the system startup config
checkbox to use this configuration file as the
switch configuration on the next boot. Ensure this file meets the switch’s initial (startup) configuration
requirements before selecting this option.
4. Refer to the
Status
field for the current state of the requests made from the applet. Requests are any
“SET/GET” operation from the applet. The Status field displays error messages if something goes wrong
in the transaction between the applet and the switch.
5. Click
OK
to save and add the changes to the running configuration and close the dialog.
6. Click
Cancel
to close the dialog without committing updates to the running configuration
3.3.3 Transferring a Config File
Transfer a configuration file to and from the switch using the
Transfer
screen. Transferring the switch
configuration is recommended to keep viable configurations available in a secure location. The following file
transfer configurations are possible:
• switch to switch, server or local disk
• server to switch
• local disk to switch
To transfer the contents of a configuration file:
1. Click the
Transfer Files
button on the bottom of the Configuration screen.
2. Refer to the
Source
field to define the location and address information for the source config file.
From
Select the location representing the source file’s current location using the
From
drop-down
menu. Options include
Server, Local Disk
and
Switch
.
File
Specify a source file for the file transfer. If the switch is selected, the file used at startup
automatically displays within the File parameter.
Using
Use the
Using
drop down-menu to configure whether the log file transfer is conducted using
FTP or TFTP.
IP Address
Enter the
IP Address
of the server or system receiving the source configuration. Ensure the
IP address is valid or risk jeopardizing the success of the file transfer.
User ID
Enter the
User ID
credentials required to transfer the configuration file from a FTP server.