Using the ir remote control unit – Gefen GEF-DVIKVM-848DL User Manual
Page 17

14
USING THE IR REMOTE CONTROL UNIT
IR Remote Control Key Mapping
Each input and output on the 8x8 DVI KVM Dual Link Matrix is represented by a
button on the IR Remote Control unit. The table below lists the corresponding inputs
and outputs.
Remote Button
Monitor / Source
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
Routing Sources using the IR Remote Control unit
Issuing a routing command is a two step process. The fi rst step is to select the
monitor where the source will be routed. The second step is to select the source.
Example 1
Route the source device connected to In 7 to the monitor connected to Out 3.
1. Press button 3 (monitor 3) on the IR remote control unit.
2. Press button 7 (source 7) on the IR remote control unit.
The source connected to In 7 will be routed to the monitor connected to Out 3.
Example 2
Route the source device connected to In 1 to the monitor connected to Out 1.
1. Press button 1 (monitor 1) on the IR remote control unit.
2. Press button 1 (source 1) on the IR remote control unit.
The source connected to In 1 will be routed to the monitor connected to Out 1.