GSI Outdoors 100 SERIES DRYER PNEG-552 - Manual (Page 14)

14 PNEG-552 100 Series Dryer
3. Dryer Control Panel
Unload Switch
The UNLOAD switch turns the metering rolls and discharge auger ON or OFF, and selects the operation
of the metering rolls.
• In the 2 Speed position, if the MOISTURE CONTROL switch is ON, and the drying mode switch
is turned to continuous flow, the metering roll speed will alternate between the high speed
metering roll potentiometer setting and the low speed metering roll potentiometer setting,
depending on the control signal from the moisture control thermostat. The discharge auger will
operate continuously.
• In the 1 Speed position, if the MOISTURE CONTROL switch is ON, and the drying mode switch
is turned to continuous flow, the metering roll speed will operate at the high speed metering roll
potentiometer setting or turn off depending on the control signal from the moisture control
thermostat. The discharge auger will operate whenever the metering rolls are operating.
• In both the 1 Speed and the 2 Speed position, if the MOISTURE CONTROL switch is OFF, and
the drying mode switch is turned to continuous flow, the metering roll speed can be manually
controlled by adjusting the high speed metering roll potentiometer. The discharge auger will
operate continuously.
• If the drying mode switch is turned to staged batch, the UNLOAD switch should be set to the
1 Speed position. The discharge auger and metering rolls will only operate during the unload
cycle of the staged batch operation, and the speed of the metering rolls is adjusted using the
high speed metering roll potentiometer.
NOTE: If the unload auxiliary motor overload relay is being utilized in the dryer control panel, the same
switch will also control the operation of the auxiliary equipment.
Low Speed Metering Roll Potentiometer
Use this to adjust the low speed of the metering roll when the 2 Speed automatic moisture control feature
of the dryer is in use.
High Speed Metering Roll Potentiometer
Use this to:
• Set the high speed of the metering roll when the 2 Speed automatic moisture control feature of
the dryer is utilized.
• Set the speed of the metering rolls when the 1 Speed automatic moisture control feature of the
dryer is utilized.
• Set the speed of the metering rolls during continuous flow operation when the moisture control
is not used.
• Set the rate of grain discharge from the dryer during the unload cycle of staged batch dryer operation.
Dryer Power Start Switch
This switch starts and operates the dryer based on switch settings. If other switch settings are in the OFF
position, individual dryer components can be operated by turning the drying mode switch to continuous
flow, pressing the dryer power start button and then turning on the desired dryer component.