Stovax Ceramica Gazco Ceremica Log Effect Stove Range - Manual (Page 17)

17
SERVICING INSTRUCTIONS
REPLACING PARTS
1. GENERAL
1.1 All principal components can be replaced without removing
the stove from its installation, although it will be necessary to
remove the door and ceramic outer casing in order to access
most components. In order to remove the casing, use the
following procedure:
1.2 Remove the door retaining nuts using the tool provided and
place the door to one side.
1.3 Carefully remove the top blanking plate and grille and place
to one side, gently remove the top ceramic panel, see
Diagram 1. If the unit has been connected to a top exit flue,
it will be necessary to lift and support the grille and top
ceramic panel whilst removing the outer ceramic
components.
1.4 Gently lift the front ceramic panel, and pull away from the
sub-frame to clear the retaining bolts, see Diagram 2.
1.5 Carefully remove the two side panels by lifting, and gently
pulling clear of the retaining bolts, see Diagram 3. It may not
be necessary to remove both of the side panels. This should
allow full access to all major components.
2. MAIN BURNER
2.1 Turn the gas supply off at the isolation device, remove the
door and place to one side, carefully remove the ceramic
fuel bed components.
2.2 Remove the three securing screws, two at the rear and one
at the front left-hand side. See diagram 4. Raise the left-
hand side of the burner to clear the bracket, draw the left-
hand side forward. The burner venturi is engaged over the
injector. When removing the burner be sure to clear the
injector, this will release the right-hand side of the burner.
Take care when removing the burner so as not to damage
the pilot burner.
2.3 To replace the burner, engage the venturi over the injector
ensuring the burner sits on top of the fixing bracket. Push
the burner to the right and whilst holding, insert the three
fixing screws.
AR0492
1
AR0490
2
AR0488
3
AR1605
4