Stovax Ceramica Gazco Ceremica Log Effect Stove Range - Manual (Page 13)

5.8 Carefully insert the front coal retainer into the front panel of
the firebox. Take care not the scrape/damage the logs. This
coal retainer sits in two brackets. Ensure it is fully inserted,
leaving approximately a 4 mm gap between the firebox
ledge and the bottom of the coal retainer.
5.9 Ensure that the fibreglass seal on the back of the door is
intact, locate the door on the four studs and slide back to
the firebox. Secure in place using the four dome nuts and
tool supplied, do not overtigthen the nuts.
NEVER OPERATE THE STOVE WHEN THE DOOR
IS REMOVED OR WHEN THE GLASS IS BROKEN.
6. LIGHTING
6.1 Full instructions are given in the User section under Lighting
the Stove.
13
5.5 There are two ash panels which lay across the front of the
burner skin. Place the panel with the flat edge facing the left
side of the firebox. There are location holes on this log
which fit over the screw holes of the burner skin.
5.6 Place the second ash panel to the right of the first, with the
pointed end of the panel fitting into the V shape. This panel
should locate on the screw holes of the burner skin. Ensure
that both logs are horizontal to the burner ports.
5.7 Place log E across from the rear of log A to log C on the
right-hand side. Again, there are cut-outs for location. The
front of the log should sit on the front ash panels and should
fit tight to log C. See diagram 12.
INSTALLATION INSTRUCTIONS
INSTALLATION
10
AR1614
11
AR1615
12
AR1616
13
AR1617