FIC A360 - Manual (Page 127)

Maintenance & Disassembly
3. Release keyboard cable by sliding the ZIF connector towards up direction.
Figure 5-3 Remove keyboard
5.5.3 Removing the Palm Rest and Glide Pad
Follow the procedure below on how to remove them:
1. Remove the five screws securing the palm-rest cover underneath the system base unit.
screws
Figure 5-4 Remove Palm Reset
2. Remove the palm-rest cover by slowly unsnapping each section of the palm-rest cover
from the base unit.
3. Slowly lift the cover case, and you will find two cables connected to the main board. One
is from glidepad, and another one is from Audio DJ panel. Pull the glidepad cable and
Audio DJ panel from the main board to separate the palm-rest cover from the system unit.
FIC A360 Service Manual 5-7