Fitness Quest 1400 - Manual (Page 8)

STEP 1 - Upright Assembly
a) Stand on Walking Belt and grip the
uprights and slowly raise them into
the assembled position. Secure the
right side with (2) M8 x 20mm Allen
Bolts (1) M8 Washer and (1) M8
Curved Washer at the bottom of the
right Upright as shown in Figure 1.
Repeat on other side.
b) Use the Allen Wrench provided to
tighten.
STEP 2 - Console Base Assembly
Note: To assure Console Base Assembly does
not fall, hold onto Hand Grips while assembling.
a) While standing on the Walking Belt put the
Console Base Assembly in the user position by
pivoting it carefully down making sure the wires
are connected on the right side. See Figure 2a.
Note: During assembly, DO NOT PINCH WIRES
when the Console is folded down and secured
to the Upright.
b) Attach the Console Base
Assembly to the Uprights
by using an M8 x 20mm
Allen Bolt and M8 Curved
Washer.
Repeat on other side.
Tighten with Allen Wrench
provided. See Figure 2b.
2a
2b
upright
RIGHT SIDE
M8 curved
washer
Figure 1 - Install Uprights
Figure 2 - Install Console Base
M8 x 20mm
allen bolt
M8 washer
M8 x 20mm allen bolt
M8 curved
washer
walking belt
console base
assembly
upright
hand
grip
Note: We recommend setting up the
unit in the area where it will be used.
Remove Box Top. Collapse Box Bottom
and leave unit in box to assemble.
7