Fujitsu Siemens Computers N6210 - Manual (Page 17)

17
BOOT MENU – SELECTING THE OPERATING SYSTEM SOURCE
The Boot Menu is used to select the order in which the
BIOS searches sources for the operating system. Follow
the instructions for Navigating Through the Setup
Utility to make any changes. (See Navigating Through
The Setup Utility on page 2 for more information.) The following tables show the names of the menu fields
for the Boot menu and its submenu, all of the options
for each field, the default settings and a description of
the field's function and any special information needed
to help understand the field's use.
Figure 17. Boot Menu
Table 17: Fields, Options and Defaults for the Boot Menu
Menu Field Options Default Description
QuickBoot ■ (Selected)
■ ___ (Unselected)
When selected, fewer Power On Self Tests are run in order to
speed up booting. When unselected, all Power On Self Tests are
run. (Fewer tests mean faster turn on.)
Boot-time
Diagnostic
Screen ■ (Selected)
■ ___ (Unselected)
___] Turns on and off display of test results instead of Fujitsu logo
screen during Power On Self Test.
Boot Menu ■ (Selected)
■ ___ (Unselected)
This field is not active unless the Supervisor’s Password has been
set. When unselected, access to the Boot Menu with the [F12] key
is disabled. When selected, the Boot Menu is enabled and the
[F12] key will allow you to display it.
Preboot
Execution
Environment ■ (Selected)
■ ___ (Unselected)
___ Turns on and off the preboot execution environment feature.
Boot Sequence
Setting ___ ___ When multiple hard drives are used with the system, this menu
allows setting up the order in which the hard drives are sequenced.
See “Boot Sequence Setting Submenu” in the following section.
4040M9AT00
ITADVD-RAM UJ-831S
CPU
Intel(R) Pentium
Speed:
L1 Cache:
L2 Cache:
Quick Boot
__ __ Boot Time Diagnostic Screen
Boot Menu
__ __ Preboot Execution Environment
Boot Sequence Setting
B o o t M e n u