Fujitsu Siemens Computers LifeBook B3000 - Manual (Page 6)

6
L i f e B o o k B S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA/
ATAPI devices are installed.
Note: Actual hard drive label shown may vary. Depending
on the drive type, information such as cylinders, heads and
sectors may or may not be displayed.
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options Default Description
Type: n Auto
n None
n CD-ROM
n Hard Disk
[Auto] Selects the ATA/ATAPI device type. Select Auto to have the type auto-
matically identified by the BIOS at POST. If None is selected, all of the
following Set-up items do not appear. Select CD-ROM if a CD-ROM
drive is installed at this connection. If Hard Disk is selected, you must
specify the number of Cylinders, Heads, and Sectors for the drive.
LBA Format Logical Block Addressing (LBA)
Total Sectors: ___ ___ The total number of sectors on your hard disk
Maximum
Capacity: ___ ___ The maximum capacity of your hard disk
CHS Format Cylinders/Heads/Sectors
Cylinders: n A number between
0 and 65,535
–— This item is active only when Hard Disk is selected as the type. This
field is changed by incrementing (pressing the [Spacebar]), by typing in
the number, or using the “+” and “-” keys.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
▲
Main Advanced Security Power Boot Info Exit
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Primary Master [HITACHI_DK23EA-30-(PM)]
Type: [ Auto]
LBA Format
Total Sectors:: 58605120
Maximum Capacity: 30006MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
Transfer Mode: [Multiword DMA 2]
Ultra DMA Mode: [Disabled]