FUJITSU C-7661 - Manual (Page 6)

6
L i f e B o o k C S e r i e s B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed. *Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options Default Description
Type: n Auto
n None
n CD-ROM
n Hard Disk
[Auto] Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all of the
following Set-up items do not appear. Select CD-ROM if a CD-ROM drive
is installed at this connection. If Hard Disk is selected, you must specify the
number of Cylinders, Heads, and Sectors for the drive.
Cylinders: n A number
between
0 and 65,535
–— This appears only when Hard Disk is selected. When Hard Disk is selected,
you can change the value. This field is incremented by pressing the
[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
the [-] key. You can also change the field by typing in the number.
Heads: n A number
between
1 and 16
–— This appears only when Hard Disk is selected. When Hard Disk is selected,
you can change the value. This field is incremented by pressing the
[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
the [-] key. The field can also be changed by typing in the number.
Sectors: n A number
between
0 and 63
–— This appears only when Hard Disk is selected. When Hard Disk is selected,
you can change the value. This field is incremented by pressing the
[Spacebar]) or by pressing [Shift] [+]. This field is decremented by pressing
the [-] key. The field can also be changed by typing in the number.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu -/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Primary Master [TOSHIBA MK3018GAP -(PM)]
Type: [ Auto ]
Maximum Capacity: 30006MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
PIO Transfer Mode: [Fast PIO 4]
DMA Transfer Mode: [Ultra DMA 5]
▲
ErgBIOS.fm Page 6 Thursday, February 7, 2002 4:13 PM