Fujitsu Siemens Computers S2110 - Manual (Page 27)

27
EXIT MENU – LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow the instructions for Navigating Through the Setup Utility to
make any changes. (See Navigating Through the Setup Utility on page 2 for more information). The following table
shows the names of the menu fields for the Exit menu, the default settings and a description of the field's function and
any special information needed to help understand the field's use.
Figure 18. Exit Menu
Table 18: Fields, Options and Defaults for the Exit Menu
Menu Field Description
Exit Saving
Changes Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory and
then exit the setup utility. A confirmation message
Save Configuration changes and exit now? [Yes]
[No] will be displayed.
Exit Discarding
Changes Selecting Exit Discarding Changes and Exit will exit the setup utility with out writing to the BIOS memory. When the
BIOS recognizes this selection it will load the operating system and begin operation.
Load Setup
Defaults Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the message
Load default configuration now? [Yes] [No]. When confirmed the setup utility will return to the Exit
Menu. To return to another menu follow the directions in the Navigating Through the Setup Utility Section.
Discard Changes Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message Load
previous now? [Yes] [No] will be displayed. When confirmed the utility will return to the Exit menu. To
return to another menu, follow the directions in the Navigating Through the Setup Utility Section.
Save Changes Selecting Save Changes causes the new settings in all menus to be written to the BIOS memory. The message Save
configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup utility will return
to the Exit menu. To go to another menu, follow the directions in the Navigating Through the Setup Utility section.
Save Changes
and Power Off Selecting Save Changes and Power Off will cause the new settings in all menus to be written to the BIOS memory,
then power the system off. The message
Save configuration changes now and power off? [Yes]
[No] will be displayed. When confirmed, the setup utility shut down the system.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
Main Advanced Security Boot Exit
Item Specific Help
Exit System Setup and
save your changes to
CMOS.
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Save Changes and Power Off
▲
E x i t M e n u