Husqvarna Walk-Behind Snow Thrower ST 121E/96183000100 - Manual (Page 21)

21
KEY PART
NO. NO.
QTY DESCRIPTION
REPAIR PARTS SNOW THROWER - - MODEL NUMBER ST 121E (96183000100)
HANDLE ASSEMBLY
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
1 532 44 32-45 1 SUBASM.CONTROL.SHROUD
2 532 44 16-24 1 COVER.HANDLE.LG.SHROUD
3 532 44 33-18 1 BRACKET.SUPPORT - DCC - STAMP - BLK
4 532 44 27-75 1 SUBASM.RH.LED
5 532 44 27-76 1 SUBASM.LH.LED
6 532 44 34-33 1 BAIL.OVERMOLD.ASM
7 532 44 22-50 4 SCREW.PAN.HD.TORX 1/4-20 X .750
8 532 14 50-06 3 CLIP.PUSH-IN.HINGED
9 532 43 75-06 1 DECAL.HANDLE BAR.AUGER INST
10 532 44 34-32 1 HANDLE.UPPER.ERGO.MS498
11 532 44 30-18 1 CABLE.CLUTCH.SSST.SHORT
12 817 41 13-18 4 HEX.WASHER.HEAD 13-16 X 1.125
13 532 13 20-04 1 HEX.NUT.1/4-20.NYLON.LOCKING
14 532 44 22-48 4 NUT.5/16-18.FLANGE.NYLOCK.BLK
15 532 85 10-74 2 WASHER.HARD
16 532 18 88-21 2 BOLT.HANDLE.ADJ
17 532 44 30-21 2 SUBASM.QUICK.ADJUST.COLD
18 532 44 22-34 1 GUIDE.ROPE
19 532 44 30-46 1 HARNESS.LED
20 817 41 13-12 8 BOLT.HEX.WSH 13-16 X 3/4
21 819 09 10-16 4 WASHER.9/32 X 5/8 X 16 GA