Harbor Freight Tools 90374 User Manual
Page 10
18.
WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known (to the State of
California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are: lead from lead-based paints, crystalline silica
from bricks and cement or other masonry products, arsenic and chromium from
chemically treated lumber. Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code 25249.5, et seq.)
19.
WARNING! People with pacemakers should consult their physician(s)
before using this product. Operation of electrical equipment in close proximity to
a heart pacemaker could cause interference or failure of the pacemaker.
20.
WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts Lists on pages 18,
19, 20, and 21 are included. If any parts are missing or broken, please call Harbor Freight
Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts mentioned in the following pages,
refer to the Assembly Diagrams on pages 18, 19, 20, and 22.
SKU 90374
PAGE 10
1.
NOTE: The Battery (1A) requires charging. The first charge requires 5 hours
charge time prior to using a cordless tool. (See Figure D, next page.)
2.
The Battery (1A) should only be re-charged when the Flashlight Bulb (7C) begins to
dim or a cordless tool begins to run slowly. (See Figure D.)
3.
When the Battery (1A) requires re-charging, a 3 to 5 hour charge allows the tool
to operate at full power. Do not re-charge the Battery longer than 5 hours, as
damage to the Battery and/or Flashlight or cordless tool will occur.
(See Figure D.)