Hisense Group KFR-3208GW - Manual (Page 12)

Adjusting the Airflow Direction
The horizontal airflow can be adjusted
by moving the vertical vanes with your
hands to the left or right.
2. Vertical
1. Horizontal
!
CAUTION
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation may
begin to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote control unit Do not
move the flap with your hands.Confirm that the remote control unit has been turned on.
Then, use the FLAP button to set either the sweep function or one of
the six airflow direction settings.
A.Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
B.Automatic Function
The flap moves up and down automatically
from to during the cooling or drying
operation, from to during the heating
operation. Referring to the above illustration.
!
NOTE The flap automatically closes when the unit is off.
!
CAUTION
¡ñ Use the FLAP button on the remote control to adjust the position of the flap.
If you move the flap by hand, the flap position according to the remote control
and the actual flap position may no longer match.If this happens,shut off the
unit, wait for the flap to close, and then turn on the unit again; the flap
position will now be normal again.
¡ñ Do not have the flap pointed down during cooling operation. Condensation
may begin to form around the air vent and drip down.
10
FLAP MODE
ON OFF
SLEEP SET CANCEL
ACL A/C SENSOR
1
2
3
4
5
6
SWEEP
COOL
and
DRY
HEAT
Adjusting the Fan Speed
A
A
B. Manual
If you want to adjust fan speed manually during operation, just set the FAN SPEED selector
as desired.[ (High), (Medium), or (Low)]
A. Automatic
Simply set the FAN SPEED selector to the position.
A microprocessor in the air conditioner automatically controls the fan speed when the mode is selected. When the air
co nditioner starts operating, the difference between the room temperature and the set temperature is detected by
the microprocessor which then automatically switches the fan speed to the most suitable level.