HP Photosmart M525 - Manual (Page 8)

Set the region
Along with the Language setting, the Region setting
determines the default date format and the format of the
video signal for displaying camera images on a
television when connected through an optional
HP Photosmart Premium dock or wireless dock base
(see
Using the Setup Menu on page 31 ).
Use to choose the region you want, then press
.
Set the date and time
1. Use to adjust the highlighted value.
2. Use to move to the other selections and repeat
Step 1 until the date and time are set correctly.
3. Press when the date, time, and format settings
are correct, then press again to confirm.
To change the date and time later, use the Setup
Menu (see
Using the Setup Menu on page 31 ).
Install and format an optional memory card
1. Turn off the camera and
open the Battery/Memory
card door.
2. Insert the memory card in
the smaller slot as shown.
Make sure the memory
card snaps into place.
3. Close the Battery/Memory
card door and turn on the
camera.
Always format memory cards
before first use.
1.
With the camera turned on, press until appears briefly in the upper right
corner of the Image Display. This indicates you are in Playback.
2. Press .
3. Use to select Format Card, then press .
4. Use to select Yes, then press to format the card.
Note Once you install a memory card, all new images and video clips are stored
on the card, rather than in internal memory. To use internal memory and view
images stored there, remove the memory card. To transfer images from internal
memory to an optional memory card, see Move Images to Card under
Using the
Design Gallery Menu on page 22 .
For information about supported memory cards, see Storage on page 43 .
Install the software
The HP Photosmart Software provides features for transferring images and video clips
to your computer, as well as features for modifying stored images (remove red eyes,
Chapter 1
8