Hotpoint BD52B/2 - Manual (Page 33)

GB
33
Care and Cleaning
(BD62SS/2 & BD52B/2 - BD52K/2 -
BD52P/2)
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer. Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to
any sharp mechanical blows.
Stubborn stains can be removed by using a fine
steel wool pad. For slight soiling the inner glass
panel may be cleaned, while still warm, without
removing it from the door. After cleaning, rinse and
dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the
weight of the inner glass when removing and
refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and
unscrew the two screws
securing the glass panel
so that the securing
brackets can be turned.
There is no need to
remove the screws completely.
2. Turn the brackets so that the glass can be removed
and cleaned at the sink (Fig. 1.).
3. The inside of the outer door glass can now be
cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER
WITHOUT THE INNER DOOR GLASS IN
POSITION.
Refit the door inner glass as follows.
1. NOTE: The inner door
glass has a special
reflective coating on one
side. Replace the door
inner glass so that the
s t a t e m e n t :
"IMPORTANT THIS FACE TOWARDS THE OVEN"
can be read from the inner side of the door.
2. Turn the two securing brackets back to their original
position to retain the glass and tighten the screws
(Fig. 2.)