Ishwasher – Hotpoint BFV680 User Manual

Page 15

ISHWASHER

Select the Normal or daily wash cycles (See Programme Chart in the instruction booklet)

and press the extra dry button, if existing

Load for 12 Standard Settings tests (upper rack at top position)

INFORMATION FOR TEST LABS

Comp1

Comp2

Comp3

This basket is equipped with two removable grids: insert
the cutlery one by one into the slots, with the handles at
the bottom. Position them so that they don't touch.

EN 50242

IEC/ DIN

Cycle

See booklet

Total detergent

30 gr.

Comp.1

Comp.2

Comp.3

See booklet

The Rinse Aid

This product makes dishes sparkle more as it improves
their drying. The rinse aid container is situated on the
inside of the door; it should be filled up when the rinse
aid indicator light “T” flashes.

Loading the Rinse Aid

To open the dispenser turn cap C in the anticlockwise
direction and then pour in the rinse aid making sure not to
overfill. The amount of rinse aid used for each cycle can
be regulated by turning the dose adjuster ‘F’ which you
will find under lid ‘C’. There are 6 different settings, the
normal dosage is setting 5.

Detergent

Detergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the
start of each wash cycle following the instructions
provided in the ‘Programme Chart’. The detergent
dispenser is located on the inside panel of the door.

Loading the Detergent

To open lid ‘A’ press button ‘B’. The cleaning detergent
should be introduced into the three containers ‘1’, ‘2’ and
‘3’ (See table at the end of the page).

After pouring in the detergent, replace the lid, pressing
down until it clicks.