Icons and features, cont – Hunter Fan 44377W User Manual
Page 47
47
5. Span setting mode – allows you to adjust the system ON/OFF
cycle rate. The default setting is 2 (the system cycles ON or OFF
when the temperature is within 1o F (0.5o C) above and below
the set temperature.) The span setting can be adjusted if your
system is cycling too fast or too slowly.
Press and hold both the
U
p
and
D
OwN
buttons until the word
SPAN appears. Use the
U
p
or
D
OwN
button to adjust the span
setting.
(Up will increase your cycle time by allowing the system to run longer;
Down will decrease your cycle time by causing the system to run for a
shorter length of time.)
Span settings remain the same for
HEAT
and
cOOl
system
settings. When batteries are installed, or the unit is
RESET
, the
span cycle will revert to 2.
icons and features, cont.