Harbor Freight Tools Chicago Electric Power Tools / Reciprocating Saw - 4.5 AMP 4095 - Manual (Page 12)

SKU 4095 For technical questions, please call 1-800-444-3353. PAGE 12
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Trigger of the Reciprocating Saw is in its “OFF” position
and that the tool is unplugged from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
2. BEFORE EACH USE, inspect the general condition of the Reciprocating Saw. Check
for loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, cracked or broken Saw Blades, and any other condition
that may affect its safe operation. If abnormal noise or vibration occurs, have the
problem corrected before further use.
Do not use damaged equipment.
3. TO CLEAN, use a clean cloth or vacuum to remove all dust and debris from the
Reciprocating Saw. Do not use any solvents.
8. Once the cutting procedure is completed, release pressure on the Trigger (37) to
stop the Reciprocating Saw. If the Trigger Lock was used, squeeze and release the
Trigger once to stop the Saw. Then, unplug the Saw from its electrical outlet.
(See Figure B.)
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANU-
FACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND
TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND
NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR
HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
PLEASE READ THE FOLLOWING CAREFULLY