Hunter Fan 30525 - Manual (Page 6)

41960-01 6
Operation
Initial Operation
This section provides basic instructions on the use of your air purifier. After following these
initial directions, please continue reading this booklet to learn how to operate the more
advanced features of your air purifier.
Basic Operation of the Air Purifier:
1. Take the air purifier out of the box and remove the clear plastic protective bag.
Place the unit on a firm level floor.
2. Before turning on the air purifier, you need to confirm that the filters are firmly
in place and have not become loose during shipping. To check the filters, open
the front grill by placing your fingers under the handle and pulling the front grill
towards you. The front grill will rest open at about 45º. You can remove the front
grill by placing your fingers under the handle and pulling the front grill towards
you and then up.
Fig. 5 Fig. 6
PULL
FORWARD,
THEN UP
HANDLE
3. Next, check the HEPA filter by pressing firmly on all four corners of the filter to
ensure that it is fully inserted into the filter opening.
4. The carbon pre-filter is mounted inside the front grill with hook tape. Confirm
that it properly covers the grill vents. You may notice a few black particles com-
ing off the pre-filter. Those particles are part of the odor-removing activated car-
bon and will be collected on the filter during use.
5. Place the front grill back onto the unit. First, line up the tabs on the bottom of
the grill with the openings on the purifier base and then push the top of the
grill forward until it is closed. NOTE: This unit will not operate unless the
grill is in the correct position.
41960-01_rev 1-13-06.pmd 1/13/06, 4:50 PM 6