Hitachi VT-F372A - Manual (Page 63)

Advanced Operations (Synchro Editing)
63
Advanced Operations (Synchro Editing)
Synchro Editing
Tape copying is much easier if you can connect VCR1 and VCR2 with a synchro edit
cable. This lets you use a single set of controls to govern both VCRs.
We assume that VCR2 is your model VT-F372A. This is the playback VCR.
The other VCR must be a Hitachi and must have a jack labeled EDIT. This is the
recording VCR.
You will need to purchase a synchro edit cable. You may order by calling 1-800-
HITACHI. Ask for part number VTCH40S.
Remember to switch the remote control between VCR1 and VCR2 mode, depending
on which device you are signalling.
Hookup When VCR1 is Recording
Hook up the two VCRs and the TV as shown on page 56.
Connect the synchro cable from EDIT on VCR1 to EDIT on VCR2.
Synchro Edit Procedure When VCR1 is Recording
Turn the power on to both VCRs and the TV.