Harbor Freight Tools 47214 - Manual (Page 11)

Page 11 For technical questions, please call 1-800-444-3353. Item 47214
Sa
FE
tY
Op
ER
ati
O
n
m
aint
Enanc
E
SE
tup
General Operating instructions
1. If an automatic oiler is not used, add a few
drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
2. Connect the air hose to the air inlet of the tool.
3. Turn Direction Lever to the desired orientation.
Set to Forward (clockwise rotation) by turning to
(F) position; set to Reverse (counterclockwise)
rotation by turning to (R) position.
4. If attaching hardware, thread the hardware
(nut/bolt) in place a turn or two before using
the tool to help prevent cross-threading.
5. Place the drive socket over the hardware to be
tightened or loosened. Hold the tool firmly and
squeeze the Throttle. Do not hold the socket.
6. When job is done, release Throttle.
7. If the tool requires more force to accomplish
the task, verify that the tool receives sufficient,
unobstructed airflow (CFM) and increase the
pressure (PSI) output of the regulator up to the
maximum air pressure rating of this tool.
cautiOn! tO pREVEnt injuRY FROm
tOOl OR accESSORY FailuRE:
Do not exceed the tool's
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required. Do not use
a handle extension to increase torque.
8. To prevent accidents, turn off the tool, detach
the air supply, safely discharge any residual air
pressure in the tool, and release the throttle and/
or turn the switch to its off position after use.
Clean external surfaces of the tool with clean,
dry cloth, and apply a thin coat of tool oil.
Then store the tool indoors out of children's reach.