HP HEWLET HP VECTRA VA 6/XXX User Manual
Page 52
3 Troubleshooting Your PC
If Your PC Has a Hardware Problem
42
English
CD-ROM Drive is Idle
If the CD-ROM drive does not appear to be working, try accessing the
disk by clicking on the CD-ROM drive icon or drive letter assigned to
the CD-ROM drive by your operating system.
CD-ROM Drive Does Not Work
•
Check that the cables have been properly connected.
•
Check that a CD is inserted in the drive.
•
Verify that the CD-ROM is declared as “CD” in the Setup program
(refer to the IDE Devices Submenu of the Configuration Menu in the
Setup Program).
•
Verify that the
Bus IDE Adapters
item is set to
Both
in Setup
(refer to the IDE Devices Submenu of the Configuration Menu in the
Setup Program).
•
If you intend to boot on CD-ROM, make sure that this option is
enabled in Setup (refer to the Start-up Center Submenu of the
Security Menu in the Setup Program).
•
For further information refer to the CD-ROM documentation.
If an Accessory Board Does Not Work
Carry out the following checks:
•
Ensure the board has been firmly installed in the accessory board
slot.
•
Check that the accessory board has been correctly configured with
the ISA Configuration Utility if necessary.
•
Ensure the board is not using memory, I/O addresses, an IRQ, or
DMA also used by the PC. Refer to "IRQs, DMAs, and I/O Addresses
Used by Your PC", on page 51. Refer to the board’s manual for further
details.
•
Check that the PC has been configured correctly in Setup.