Door reversal – Hotpoint RFM17 User Manual
Page 17
Refit Lower Door
14.
Take off the two screw covers from the left hand centre panel and remove
the two screws. Fit these screws and covers over on the right hand side.
15.
Fit the centre hinge on the left hand side with the original screws, cover the
screws with the original covers.
16.
Using a thin blunt instrument, remove the hinge
bush cap from the top left of the lower door and fit
on the top right.
Note : You may require assistance to do this:
17.
Place the lower door onto the lower hinge pin.
18.
Offer the door up to the centre hinge.
Put the hinge pin through the centre hinge and
ensure it locates into the door. Check that the hinge
pin is positioned the right way up.
Refit Top Door
19.
Using a thin blunt instrument, remove the hinge
bush cap from the top left of the door and refit on
the top right.
20.
Replace the spacing washers onto the centre hinge bracket.
Note : You may require assistance to do this:
22.
If necessary, slacken off the screws on the centre hinge pin and
adjust the doors so that they line up with the cabinet.
23.
Adjust the front feet (see ‘Levelling’ SAFETY & INSTALLATION section).
WARNING: Failure to level the appliance correctly may result in
misalignment of the cabinet and/or doors.
Note : Let the appliance stand upright in it’s final location for at least
15 minutes before plugging in and switching on the electricity supply.
Door Reversal
17
Door Reversal continued...
11.
Unscrew the foot and hinge bracket fitted to the bottom right hand side of
the appliance. Unscrew the foot and footplate fitted to the left hand side of
the appliance.
12.
Refit the hinge bracket and footplate to the opposite sides of the appliance.
Screw in the feet until there is approximately 35mm projecting from the
bottom front edge of the appliance.
Note : You may require assistance to do this:
13.
Lift the appliance from the rear of the tabletop and stand it on its feet and
wheels.
Be careful that the appliance does not run away with you when the wheels
touch the floor.
Refit the spacing washers.
21.
Place the top door hinge onto the top left of the door, slide the
door onto the centre hinge pin. Support the door while
screwing the top hinge into position.
Ensure that the hinge bracket locates correctly.
CLEANING &
MAINTENANCE