Harbor Freight Tools 47907 - Manual (Page 3)

Page 3 For technical questions, please call 1-800-444-3353. SKU 47907
Use eye and ear protection 6. . Wear
ANSI-approved impact safety goggles
and ear protection.
do not overreach
7. . Keep proper footing
and balance at all times. Do not reach
over or across running machines.
Maintain Pump with care
8. . Keep Pump
clean for better and safer performance.
Inspect pump cords periodically; If dam-
aged, have them repaired by a qualified
technician.
disconnect power
9. . Unplug Pump when
not in use.
Stay alert
10. . Watch what you are doing,
use common sense. Do not install Pump
when you are tired.
Check for damaged parts
11. . Before us-
ing Pump, any part that appears dam-
aged should be carefully checked to
determine that it will operate properly
and perform its intended function. Check
for alignment and binding of moving
parts; any broken parts or mounting fix-
tures; and any other condition that may
affect proper operation. Any part that is
damaged should be properly repaired or
replaced by a qualified technician.
replacement parts and accessories
12. .
When servicing, use only identical re-
placement parts. Use of any other parts
will void the warranty.
Do not install Pump if under the influ-
13.
ence of alcohol or drugs. Read warn-
ing labels on prescriptions to determine
if your judgment or reflexes are impaired
while taking drugs. If there is any doubt,
do not install the Pump.
rECOMMEndEd MiniMUM WirE
gAUgE FOr EXtEnSiOn COrdS
(120 VOLt)
nAMEPLAtE
AMPErES
(at full load)
EXtEnSiOn COrd
LEngtH
25’ 50’ 100’ 150’
0 – 6 18 16 16 14
6.1 – 10 18 16 14 12
10.1 – 12 16 16 14 12
12.1 – 16 14 12 do not use.
tABLE A
USE PROPER EXTENSION CORD. 14.
Make sure your extension cord is in
good condition. When using an exten-
sion cord, be sure to use one heavy
enough to carry the current your prod-
uct will draw. An undersized cord will
cause a drop in line voltage resulting in
loss of power and overheating. Table A
shows the correct size to use depending
on cord length and nameplate ampere
rating. If in doubt, use the next heavier
gauge. The smaller the gauge number,
the heavier the cord.
Maintenance
15. . For your safety, mainte-
nance should be performed regularly by
a qualified technician.
Pump clean water only.
16. Do not use the
pump for any other application.
People with pacemakers should consult
17.
their physician(s) before use. Electro-
magnetic fields in close proximity to
heart pacemaker could cause pacemak-
er interference or pacemaker failure.
The brass components of this product
18.
contain lead, a chemical known to the
State of California to cause birth defects
(or other reproductive harm). (California
Health & Safety code § 25249.5, et seq.)
do not operate this pump if the power
19.
cord or electrical components are
damaged or the seals are compro-
mised. do not plug in the power cord
rEV 07g