beautypg.com

Т³гж 10, Ï ´ µ у л ³ р т, Washing sequence – haier HWM108VA User Manual

Page 10: Midway spinning, Wash

background image

Midway spinning

Push

Push

Proper

Proper

Outer cover of

the spin tub

Inner cover of

the spin tub

The laundries

are slanting

Gland

No gland

1.

Put the laundries into the spin tub evenly and smoothly.

2.

Spin

(1) Put the gland in properly.

Please put in the gland properly even if the laundries quantity is small.

(2) Close the inner and outer cover of the spin tub.

(3) Spin for 1-2 minutes.

9

3.

Run the foam-removing spinning.

1

2

Set the inlet selector handle on spin side and

fill water for about 1 min.

Close the spin tub outer cover and spin

for about 1 - 2 min.

In case water flows out from wash tub side

due to too much inflow, please turn down

the water tap a bit.

WATER INLET SELECTOR

WASH

SPIN

Ï ´ µ У Л ³ Р т

Not set the switch to

DRAIN during washing

Wash timer

(To set to below 2 minutes,
first set to 6 minutes then
turn it back.).

Wash selector

(Strong current,
Standard current)

Drain selector

Spin timer

(To set to below 1 minute,

first set to 2 minutes then

turn it back. it can increase

the service life of the timer).

WATER INLET SELECTOR

Page7

Page7

WASH

SPIN

1.Water-filling selector
1 Set the water inlet selector at the "WASH" side.
(Figure 1)
2 Set the water level adjusting lever to needed line.

2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.

3.Put in the laundries. If the water quantity is
insufficient, please add water.

4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)

5.Select the washing time
Select the washing time according to the laundries.
(Figure 4)

6.After washing, set the "WASH SELECTOR"
at "DRAIN". (Figure 5).

Wash

Figure 1

Figure 2

Figure 3

Figure 5

Figure 4

Remarks:
1. 0~15 minute is the normal washing.
2. 15~45 minute is active soaking. During active soaking, the pulsator
will run for 2 minutes in each 8 minutes. After the active soaking, it
will run normal washing for 15 minutes.
3. If you select soaking(i.e. turn the knob to position between 15~45
minutes), be sure to dissolve the washing powder in advance,
otherwise the washing powder may result in
damage to the laundries.

Washing sequence

8

STRONG

STANDARD

4

4

3

3

2

2

1

1

5

5

STRONG

STANDARD

DRAIN

DRAIN

DRAIN

DRAIN