Honeywell HMLCD15 - Manual (Page 16)

Rev. A 6 HMMU000880
04/08/04
2.2 CONTROLS – REAR PANEL
PC
A
B
C D
E
F
G
DVR or VCR
A DC12V
B Ear
C PC Sound
D VGA
E Video Sound
F S-VHS
G Composite
AV1
Rev. A 7 HMMU000880
04/08/04
2.3 INSTALLING THE MONITOR DRIVER
You can achieve an optimal resolution and scanning rate by
installing the monitor driver as follows:
1. Insert the monitor driver diskette into the floppy diskette
drive and run INSTALL.EXE.
2. Select the monitor model then press OK.
The installation will begin immediately.
2.4 VGA CABLE
A 15-pin D-Sub connector is used as the input signal connector.
Pin and input signal are shown in the table below.
Pin Name Pin Name Pin Name
1 Red 2 Green 3 Blue
4 N.C 5 GND 6 RED-GND
7 GREEN-GND 8 BLUE-GND 9 +5V
10 Logic-GND 11 N.C 12 SDA (DDC)
13 H-sync 14 V-sync 15 SCL (DDC)