Assembly – Harbor Freight Tools 3914 User Manual

Page 7

Page 7

For technical questions, please call 1-800-444-3353.

SKU 3914

aSSeMBly

Sewing Machine

Motor

power

Switch

Knee lifting arm

for presser Foot

table Stand and

top (not provided)

Figure 1

The assembly instructions describe mounting

the Single-Needle Sewing Machine (Model

03914) to the Table Stand (Model 03929), not

included. In order to complete this procedure,

you must first purchase and assemble the

Table Stand Kit (Model 03929).

installing the Oil pan and Sewing Machine

to the tabletop of industrial Sewing

Machine table (SKu 3929 - sold separately)

Figure 2

Rubber Cushions (24g)

Rubber Pads (23g)

Corner Rests

Oil Pan (1g) hole

in Tabletop (30)

(Operator Side of Table)

1. Working in the rectangular hole of the

Tabletop where the Oil Pan (1g) will sit:

Place the Rubber Cushions (24g) on

the operator-side corner rests, and the

Rubber Pads (23g) on the hinge-side

corner rests. Secure with two Tacks

(25g) in each Pad or Cushion.

note: The Rubber Pads (23g) are optional.

They may be omitted, or used under the

Rubber Cushions (24g) to adjust the tilt

of the machine, depending on the user’s

preference.

Figure 3

Back of

Sewing

Machine

Hinge (1h)

Hinge Indentations in Tabletop

Oil Pan (1g)

2. Seat the Oil Pan (1g) on the Rubber

Pads and Cushions in the Tabletop

opening.
Insert the Hinge Cushions (2h) into the

tabletop, securing them with two Tacks

(25g) in each Hinge Cushion.
Insert the Hinges (1h) into the holes in

the back of the Sewing Machine.

Machine rest

pin (19h)

Figure 4

5. Insert the Machine Rest Pin (19h) in the

hole provided in the table stand.
Carefully place the machine, hinge side

first, into the Rubber Hinge Plates and

over the Oil Pan.

reV 07f, 10b