Hayter Mowers Harrier 56 561F - Manual (Page 27)

1
Fig. 2
3. If the distance between the clutch lever and handlebar is less than
60mm regulate the engagement position with the black plastic
cable adjuster. Refer to Fig 1 and 2 to regain the 60mm distance.
4. Note this is a temporary adjustment and at the nearest
opportunity a service should be carried out to ensure the spring
on the clutch cable is attached to the gearbox clutch. This
adjustment should be done using the metal adjuster at the control
with the plastic adjuster reset fully wound in. When the spring is
set tighten the inner lock nut to secure position.
Lubricate the wheels, pivot points and linkages with engine oil every
25 operating hours.
Apply a good quality medium grease to the inner control cables at the
point of entry and exit from their outer casing.
1.27
Lubrication
MOWER MAINTENANCE
Clutch Cable Adjustment
Continued
HAY-G00147-A
13mm
extension
Clutch
spring
Fig. 3
HAY-G00146-A
Tighten the inner
nut when the cable
spring is set.
Clutch lever
fully engaged
Metal
adjuster
Fig. 4
111-1471 (C) 29/8/08 12:56 pm Page 1.27