Hayter Mowers Harrier 56 561F - Manual (Page 17)

To prevent engine damage do not use the mower on slopes greater
than 20 degrees.
To adjust the height of cut: Grip the lever and pull sideways to
disengage it from the locking notch, then push forwards to lower or
pull backwards to raise the height of cut. Finally release the lever at
the required position and ensure it locks firmly into one of the eight
setting notches.
Always select a height of cut to suit operating conditions. Aim to
prevent engine overloading and blockages by avoiding low cuts in
long grass conditions. Be prepared to make two cuts when the grass is
long.
1.17
MOWER THE OPERATING
Height of Cut
305113
CS284
B
Slopes
111-1471 (C) 29/8/08 12:56 pm Page 1.17