Hotpoint LI2SNA - Manual (Page 4)

– operation 1) and mark 2 holes with a pencil, drill the
holes (Ø8mm), insert 2 wall plugs.
12. Fix the chimney support bracket to the wall using
two 5x45mm screws.
13. Hook the hood onto the bottom bracket.
14. Fix the hood into its final position on the wall
(ABSOLUTELY ESSENTIAL).
15. Connect a pipe (pipe and pipe clamps not
provided, to be purchased separately) for discharge of
fumes to the connection ring located over the suction
motor unit.
If the hood is to be used in ducting version, the other
end of the pipe must be connected to a device
expelling the fumes to the outside. If the hood is to be
used in filter version, then fix the deflector F to the
chimney support bracket G and connect the other
extremity of the pipe to the connection ring placed on
the deflector F.
16. Make the electrical connections.
17. Apply the chimney stacks and fasten them at the
top to the chimney support „G“ (17b) using 2 screws
(17a).
18. Slide the bottom section of the chimney down until
it completely covers the suction unit and slots into the
housing provided on top of the hood.
Replace the grease filter/s (and where foreseen the
grease collecting panels) and check that the hood is
operating correctly.
17b
17b
4-13
4-13 1
2
3
9
10
5
6
11
11
12
15
17a
17a
6
5
16
B
G
H
8
8
7
17
18
5
6
10
9
14
14