Hustler Turf Mini Fastrack - Manual (Page 25)

601156_1106 23
WARNING: Failure to correctly torque the bolt may result in
the loss of the blade which can cause serious injury.
WARNING: Mower blades are sharp and can cut. Wrap the
blade(s) or wear gloves and use extra caution when servicing
them.
Seat adjustment
Mini FasTrak 36/42 - The seat can be adjusted forward and rearward by
removing the locknut that locks the seat platform in place and pivoting the
seat platform up and forward. Then loosen the four cap screws on the under-
neath side of the operator’s platform. Position the seat where you have the
best control of the machine and are the most comfortable and then tighten the
cap screws. Fig. 4-9
FasTrak 48/54 - The seat can be adjusted forward and rearward by slid-
ing the seat release handle and moving the seat until a comfortable operating
position is attained. Fig. 4-10
Steering control lever adjustment
The steering control levers can be adjusted for operator comfort. By
loosening the cap screws that attaches the upper control lever to the lower
lever (Fig. 4-11), the upper control lever can be pivoted to fit the operator’s
personal preference.
The steering control levers can also be adjusted up and down. Remove
the cap screws and slide the upper control lever up or down and align the
holes in it with the holes in lower lever. Re-install the cap screws and
tighten.
The steering control levers should be adjusted so that they align with
each other when in the neutral position.
Figure 4-11
Upper
control
lever
Lower
control
lever
Mini FasTrak 36/42
Cap screw
Figure 4-1
Mini FasTrak 36/42 shown
Cap screw
Figure 4-10
Figure 4-9
Seat
release
handle