Harbor Freight Tools 98676 - Manual (Page 14)

Page 14 SKU 98676 For technical questions, please call 1-800-444-3353.
FIgurE J
FIgurE K
SpEED cONTrOL
LEVEr
(48-4)
SpEED LABEL
(49)
Loosen the Tailstock Lock Handle 8.
(59) to move the Tailstock (65). Push
the Tailstock to the desired position
on the Bed (38). Then retighten the
Tailstock Lock Handle to lock the Tail-
stock in position. (See Figure L.)
The Tailstock Spindle (62) can extend 9.
up to 2-7/16” from the Tailstock (65)
housing. You can move the Tailstock
Spindle (62) by loosening the Handle
Assembly (64) and then turning the
Handle Wheel (67). Make sure to
retighten the Handle Assembly prior
to turning on the Lathe.
(See Figure L.)
The Tailstock Spindle (62) is hollow
10.
and can be accessed from the Han-
dle Wheel (67) end. Use the Push
Out Rod (22) to remove the center
cup or to drill holes through the center
of a workpiece. (See Figure L.)
FIgurE L
HANDLE ASSY.
(64)
TAILSTOcK LOcK HANDLE
(59)
HANDLE
WHEEL
(67)
TAILSTOcK SpINDLE (62)
The Tool Rest (60) can be used with 11.
or without the Extension Tool Rest
(58). (See Figure M, next page.)
To move the Tool Rest Body (56), 12.
loosen the Handle Assembly (57),
and move the Body to the left or right
and back or forth. Then retighten the
Handle Assembly when the Tool Rest
Body is in the desired position.
(See Figure M, next page.)
When using the Extension Tool Rest
13.
(58), make the necessary adjust-
ments using the two Handle Assem-
blies (57) to position the Tool Rest
(60). (See Figure M, next page.)
Tighten the Handle Assemblies (57) 14.
and make sure there is adequate
clearance between the workpiece and
the Tool Rest assembly before turning
on the Lathe.
(See Figure M, next page.)