HONDA Automobile Accessories User Manual

Page 8

8 of 10

AII 21619 (0008)

23. Assemble three fuse cases as shown. Attach the

appropriate fuse label to each fuse case of the
keyless entry wire harness, then attach the
connector clip as shown.

26. Position the 5-pin and 4-pin relays on the relay

bracket, and install the 6 mm washer-bolt and
6 mm nut.

24. Position one relay bracket on the left knee bolster,

and install one 6 x 12 mm washer-bolt and one
6 mm flange nut. Push the connector clip on the
fuse case of the keyless entry wire harness into
the hole in the relay bracket.

25. Secure the keyless entry wire harness to the

vehicle harness with one long wire tie in the area
shown.

27. Plug the 6-pin and 4-pin connectors of the keyless

entry wire harness into the 5-pin and 4-pin relays;
then attach the other relay bracket to the steering
hanger beam with the other 6 x 12 mm washer-bolt
and one 6 mm flange nut.

FUSE CASE
OF KEYLESS
ENTRY WIRE
HARNESS

FUSE LABEL
(15 A)

FUSE LABEL
(5 A)

6 x 12 mm
WASHER-
BOLT

RELAY
BRACKET

LONG
WIRE TIE

CONNECTOR
CLIP

LEFT
KNEE
BOLSTER

VEHICLE
HARNESS

6 mm
FLANGE
NUT

4-PIN
RELAY

5-PIN
RELAY

5-PIN RELAY

6 mm
WASHER-
BOLT

RELAY
BRACKET

About
45°

5-PIN RELAY
(with 6-pin
connector)

6-PIN
CONNECTOR

4-PIN
RELAY

4-PIN
CONNECTOR

5-PIN RELAY

6 x 12 mm
WASHER-
BOLT

STEERING HANGER BEAM

6 mm
FLANGE NUT

4-PIN
RELAY