HONDA Automobile Accessories User Manual

Page 5

AII 21619 (0008)

5 of 10

12. Push the wire tie with clip into the hole in the back

of the control unit bracket. Position the control unit
bracket on the driver's dashboard lower cover, and
install the three self-tapping screws from the kit.

14. From the driver's side, route the 14-pin connectors

of the keyless entry wire harness to the left fuse
box. Unplug the vehicle harness 14-pin connector
from the fuse box, and plug the 14-pin connectors
of the keyless entry wire harness in between.

13. Position the control unit on the control unit bracket,

and install the two 4 x 30 mm washer-screws.
Secure the antenna to the control unit bracket with
the wire tie with clip you just installed. Secure the
antenna to the control unit bracket, parallel with the
control unit.

WIRE TIE
WITH CLIP

CONTROL
UNIT
BRACKET

BACK OF DRIVER'S
DASHBOARD
LOWER COVER

SELF-
TAPPING
SCREW

ANTENNA

WIRE TIE WITH CLIP

CONTROL UNIT
BRACKET

CONTROL
UNIT

4 x 30 mm
WASHER-
SCREW

KEYLESS
ENTRY WIRE
HARNESS

VEHICLE HARNESS
14-PIN CONNECTOR

LEFT
FUSE BOX

KEYLESS ENTRY
WIRE HARNESS
14-PIN CONNECTOR