haier HDB24EA - Manual (Page 25)

English
Dishwasher is leaking
• Dishwasher is not properly leveled.
You need to place the dishwasher on a flat hard surface. Avoid an
uneven surface.
• Make sure the dishwasher is properly leveled. (See the installation
instructions)
• Do not overfill the detergent or the rinse agent dispenser because it will
cause over sudsing and overflowing.
• Do not use regular type hand or dish washing detergent in the detergent
dispenser. These types of detergents are not recommended for
dishwasher use.
Dishwasher will not fill
• Check the water supply.
Make sure that the water supply is in "ON" position.
• Check water pressure. Make sure the water pressure is at the proper
level. (Between 20 – 120 PSI)
• Is the overfill protection float able to move up and down freely. If not,
press down to release.
Detergent found in the compartment
• Do not load items too close to the detergent compartment. This may
block the automatic release of the detergent.
• Do not use old or caked/dried detergent in the compartment because it
will not dissolve properly and will leave a sandy residue on dishware.
• Is the cycle complete? The cycle may not be complete.
Dishwasher is running for too long
• The temperature of incoming water is below 120˚F. Raising your water
heater setting will help to shorten the time of operation.
• Call the Haier Customer Satisfaction Center if this does not resolve the
problem.
24