Hitachi 50VS69A 55VS69A - Manual (Page 38)

On-Scr
een Display
Channel Manager
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1. Press CURSOR PAD ̆, ̄ or CHANNEL UP/DOWN
buttons to highlight function.
2. Press the SELECT button or CURSOR PAD ̈ to
select.
Signal Meter
Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: The Signal Meter will not be available (grayed
out) when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
Channel Manager
Setup
Timers
Locks
Channel Manager
Audio
Video
Move SEL Select
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Move SEL Select
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Move SEL Select
Signal Meter
Channel Manager
Move SEL Return
Channel 3- 1
Strength 91
Peak 91
SNR 10
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Move SEL Select
OR
OR
Close
1. Use the CURSOR buttons to highlight
AIR, CABLE (1) or CABLE(2) source.
2. Press the CURSOR buttons ̇ or ̈ to highlight the
START or RESET option.
3. Press the SELECT button to select.
̇
or
̈
NOTE: 1. When a CableCARD is installed, Auto
Channel Scan will not be available since
channels will be fixed based on what was
agreed upon by you and your cable
operator.
2. If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons
̇ or ̈.
OR
Auto Channel Scan
Channel Manager
Move SEL R eturn
Source Air
Auto Channel Scan Start Reset
38