Harbor Freight Tools 52848 User Manual
Page 4
FIGURE B
UNPACKING
When unpacking, check to make sure all parts shown on the Parts List and Assembly Diagram
are included. If any parts are missing or broken, please call Harbor Freight Tools at the number
shown on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
ALL PARTS BELOW REFER TO THE PARTS LISTED AND SHOWN IN THIS MANUAL.
To Connect The Air Angle Die Grinder To An Air Hose:
1.
The Air Angle Die Grinder requires the attachment of a 1/4” NPT Quick Connector (available
from Harbor Freight Tools). (See Figure A and Figure B.)
2.
Wrap the male threads of the Quick Connector with about 3” of Teflon tape. Then, wrench
tighten the Quick Connector into the Air Inlet of the Air Angle Die Grinder.
3.
Next, connect the Quick Coupler of an air hose onto the Quick Coupler of the Air Angle Die
Grinder.
The Air Die Grinder is now ready for use.
To Insert/Change Collets In The Air Angle Die Grinder:
1.
The Air Angle Die Grinder comes with two Collets: A
1/8” Collet
and a
1/4” Collet
(part #32).
This allows the Air Angle Die Grinder to accept grinding wheels with either a 1/8” or 1/4”
shank. (See Figure B and Assembly Diagram.)
SKU 52848
PAGE 4
FIGURE A