Humax VA-ACE - Manual (Page 27)

When you use a dual LNB or two antennas connected to a
22KHz Tone switch box, make 22KHz Tone switch Enable or
Disable to select LNB or antenna.
According to the option and position of DiSEqC switch,
select Disabled, Tone Burst A to B and DiSEqC A to D.
After setting the above mentioned value, press the OK button
to move to the Manual Search menu.
The Motorised System is used to set the DiSEqC 1.2 motor by
Eutelsat specification.
If you wish to use this system, please refer to page E33.
Service Search OSD
1. If you press the EXIT button during the search, then Service
Search stops and the searching menu will appear again.
2. When you find all the services, the following picture appears.
3. Before saving it, you can select the services you want to delete.
Found services OSD
1. The picture above shows services that are found after Manual
Search.
2. Use the Red( )button to mark the services that you want to
delete. To unmark a service, select the service and press the
Red( ) button again.
3. Press the OK button to save or press the EXIT button to exit
without saving.
4. Then Service Search menu appears again. When you exit
from all menus, the first service of the found service list is
played.
In the bottom of found service picture, network, the information of
transponder and the number of found service that the services
belong to are displayed. The deleted service by the Red( )
button is excepted from counting of the number of services.
The deleted service is not included in this number.
“Free” applies to the empty space of the memory.
It will be used to store future services.
22KHz Tone
DiSEqC Input
Motorised System
E26