Hilti TE 7-C - Manual (Page 7)

2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer which fulfills the following conditions: The unit
must provide a power output in watts of at least twice the value printed on the rating plate on the power tool.
The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation
and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.
3. Insert tools, accessories
Designation Description
Chucks TE
‑C CLICK
Hammer drill bits
Ø 5…28 mm
Forming and installation drill bits
Ø 5…20 mm
Lightweight percussion core bits
Ø 25…68 mm
Multipurpose hole saws
Ø 25…82 mm, hexagonal
Pointed chisel C-type connection end
Flat chisel C-type connection end
Shaped chisels C-type connection end
Anchor-setting tools C-type connection end
Quick-release chuck for wood and metal drill bits For smooth or hex. shank
Key-type chuck With smooth or hex. shank
Wood drill bits
Ø 3…20 mm
Metal drill bits
Ø Max. 13 mm
Metal drill bits / stepped drill bits
Ø 5…22 mm
Designation Description
Dust module TE DRS-M
Angular chuck C-type connection end
4. Technical data
Right of technical changes reserved.
NOTE
The power tool is available in various voltage ratings. Please refer to the power tool’s type identification plate
for details of its rated voltage and rated input power.
en
4