Harbor Freight Tools 42933 - Manual (Page 13)

SKU 42933 For replacement parts, please call 1-800-444-3353. Page 13
9. Slide the stock to be ripped into the cutting area and verify that it slides easily beneath
the Safety Guard, Anti-kickback Arm, and (optional) Spreader Plate, and there is no
wobble space. Remove stock from cutting area.
10. Press the green Switch (122), squeeze the handle Trigger (93) (motor starts), and push
up on the Lock On Button.
11. From the side of the machine, feed the stock into the Saw Blade (against its rotation)
using a (long) push stick.
WARNING: Never use your hand to push the stock through the Saw Blade. Never reach
around the Saw Blade while it is running. Serious injury can occur to hands and arms.
12. When the cut is complete, and before removing the stock, squeeze the Trigger or pull
down on the Lock On Button, and press the red Switch.
Out-Rip Cutting
Out-ripping is done when the in-rip position will not permit a wide enough cut. This function
moves the Saw Blade to the front of the machine. This operation is the same as in-rip cut-
ting (previously described), with the exception that the Pivot Yoke is turned so that the
Handle is on the right side of the machine (opposite of the in-rip position).
1. Adjust the Saw Blade for In-rip cutting as described on page 12.
2. Loosen the Bevel Lock Knob (71) and pull out the Bevel Index Knob (74).
3. Turn the motor assembly clockwise or counterclockwise, selecting the desired angle
(variable or indexed, i.e., 45 degrees).
4. Tighten the Bevel Lock Knob (71) and push in the Bevel Index Knob (74).
5. Press the green Switch (122), squeeze the handle Trigger (motor starts), and push up
on the Lock On Button.
6. From the side of the machine, feed the stock into the Saw Blade (against its rotation)
using a (long) push stick.
WARNING: Never use your hand to push the stock through the Saw Blade. Never reach
around the Saw Blade while it is running. Serious injury can occur to hands and arms.
7. When the cut is complete, and before removing the stock, squeeze the Trigger or pull
down on the Lock On Button, and press the red Switch.