Harbor Freight Tools 92349 - Manual (Page 6)

Page 6 SKU 92349 For technical questions, please call 1-800-444-3353
Maintenance
1. When not in use, store your Impact Wrench and its accessories in its case, in a se-
cure, dry place. Protect it from water, moisture, oil, fuel, grease or other foreign
materials which may damage the case, moving parts, or electrical components.
2. This tool should only be repaired by a qualified technician.
3. The 12 Volt Plug-In (24) assembly has a fuse that will eventually need replacing.
Remove the Cap at the end of the Plug-In and replace the fuse making sure to re-
place the pieces below, in the exact same order as shown. Only replace the fuse
with another 12A-250V fuse of the same style.
Operation (continued)
Fuse
Cap
12 Volt
Plug-In (24)
CAUTION
Do not use the Impact Wrench to tighten the lug nuts.
The torque may exceed the vehicle specifications and damage may result.
9. Occasionally, you will have to manually break a nut loose before you can remove it with
the Impact Wrench. To do so, use a Breaker Bar (not included) and Socket to break the
nut loose. Then, proceed as discussed in number 8 on page 5.
10. Replace the wheel on the vehicle hub, aligning the wheel studs with the bolt holes in the
wheel.
11. Install the wheel lug nuts, following the vehicle manufacturer’s recommendations. To
avoid cross-threading the lug nuts, thread the nuts on by hand first, before using the
Impact Wrench.
12. When the wheel is securely refastened, use a torque wrench (not included) to check the
torque on all bolts and ensure that the tightness meets the manufacturer’s recommen-
dations. Check under the vehicle and remove any tools. Lower the vehicle, disconnect
the tool and replace the lift and the Impact Wrench to their storage places.