Harman-Kardon CITATION 5.1 - Manual (Page 13)

Input and Bridging Connections
The RCA jacks and bridging switches on the unit’s rear panel are used to connect
your surround processor or preamplifier to the amplifier, as well as to select the
channel configuration. Once you have determined what the channel configuration
will be, connect the output of your system to the amplifier as follows:
13
BRIDGED BRIDGED
BRIDGED BRIDGED
BRIDGED BRIDGED
– + – +
– + – + – +
Single Drive/Side Input
Back Input
Single Drive Dipole
4Ω
Dual Drive
8Ω /ch.
Single Drive Point Source
4Ω
CAUTION: Please refer to owner's manual
before making any electrical connection
to this speaker.
Single Drive/Side Input
Back Input
Single Drive Dipole
4Ω
Dual Drive
8Ω /ch.
Single Drive Point Source
4Ω
CAUTION: Please refer to owner's manual
before making any electrical connection
to this speaker.
REMOTE REMOTE
TURN ON
DC
IN ON
OFF
MANUAL
TURN ON
DC
OUT
+ –
+
–
+
–
CH 1 INPUT
(BRIDGED INPUT)
BRIDGED
MODE CH 2 INPUT
(NOT USED IN
BRIDGED MODE)
NORMAL
MODE
BRIDGED
CH 1 OUTPUT CH 2 OUTPUT
+ –
+
–
+
–
CH 3 INPUT
(BRIDGED INPUT)
BRIDGED
MODE CH 4 INPUT
(NOT USED IN
BRIDGED MODE)
NORMAL
MODE
BRIDGED
CH 3 OUTPUT CH 4 OUTPUT
REMOTE REMOTE
TURN ON
DC
IN ON
OFF
MANUAL
TURN ON
DC
OUT
+ –
+
–
+
–
CH 1 INPUT
(BRIDGED INPUT)
BRIDGED
MODE CH 2 INPUT
(NOT USED IN
BRIDGED MODE)
NORMAL
MODE
BRIDGED
CH 1 OUTPUT CH 2 OUTPUT
+ –
+
–
+
–
CH 3 INPUT
(BRIDGED INPUT)
BRIDGED
MODE CH 4 INPUT
(NOT USED IN
BRIDGED MODE)
NORMAL
MODE
BRIDGED
CH 3 OUTPUT CH 4 OUTPUT
REMOTE REMOTE
TURN ON
DC
IN ON
OFF
MANUAL
TURN ON
DC
OUT
+ –
+
–
+
–
CH 1 INPUT
(BRIDGED INPUT)
BRIDGED
MODE CH 2 INPUT
(NOT USED IN
BRIDGED MODE)
NORMAL
MODE
BRIDGED
CH 1 OUTPUT CH 2 OUTPUT
+ –
+
–
+
–
CH 3 INPUT
(BRIDGED INPUT)
BRIDGED
MODE CH 4 INPUT
(NOT USED IN
BRIDGED MODE)
NORMAL
MODE
BRIDGED
CH 3 OUTPUT CH 4 OUTPUT
COMPOSITE VIDEO
TRIGGERS
AUDIO OUTPUTS AUDIO INPUTS
IN 5 IN 6 IN 7 IN 8 REC A OUT
MONO SUB
SIDE BACK REC A OUT REC B OUT CENTER FRONT STEREO SUB FRONT 1 2 3 4 7 8 6 5
L
R
L
R
REC B OUT
IN 1 IN 2 IN 3 IN 4 AUX
OUT MAIN OUT
CALIBRATION
MICROPHONE
1 2 PWR IR
IN
P O W E R
120V ~ 50/60Hz 50 WATTS
S – VIDEO
IN 1 IN 2 IN 3 IN 4 AUX
OUT AUX
OUT REC B OUT REC A OUT
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
C A U T I O N C A U T I O N
RISK OF ELECTRIC SHOCK DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO
RAIN OR MOISTURE. DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
Manufactured under license from Dolby Laboratories Licensing Corporation. Additionally licensed under Canadian patent number 1,037,877. "Dolby", "Pro Logic" and the
Double-D symbol are trademarks of Dolby Laboratories Licensing Corporation.
Manufactured under license from Lucasfilm Ltd. U.S. patent numbers 5,043,970; 5,189,703; abd 5,222,059. Foreign patents pending. Lucasfilm and THX are registered
trademarks of Lucasfilm Ltd.
CITATION BUS
SERIAL
NUMBER
7.0 AV Controller
A division of
Hayward, CA. Designed and Manufactured in the USA.
Additionally licensed under U.S. patent numbers 5,172,415; 5,263,087; 5,199,075; 5,307,415; 5,280,528; 5,339,363; 5,295,189; 4,932,059; and patents pending.
L
R
L
R
SURROUNDS
Note: Both switches
should be in “Bridged”
position – this is Two-
channel operation mode.
A jumper is used to
connect both pairs of
negative (“-”) terminals.
Note: Switch between
Ch. 1 & Ch. 2 should
be in “Normal” position .
Switch between Ch. 3
& Ch. 4 is in “Bridged”
position – this is Three-
channel mode. A jumper
is used to connect the
Ch. 3 & Ch. 4 speaker
negative (“-”) terminals.
Note: Both switches
should be in the “Normal”
position – this is Four-
channel operation.
Figure 2 System Connections
Citation 7.0 Controller
Citation 5.1
Amplifier
Citation 5.1
Amplifier
Citation 5.1
Amplifier
Subwoofer
Speakers
Front Channel
Speakers
Citation
Dual Drive ™
Dipoles