Hatco FST-1-MN - Manual (Page 6)

INSTALLATION
4 Form No. MNM-0702
Chip Deflector
Floor Panels
Decal-Install on
upper stainless
steel panel.
Install chip deflector in slots located behind upper
door panel.
Figure 5. Set-Up (FDW-1-MN shown)
SET-UP
The Macho Nacho ™ unit comes pre-assembled
and ready for set-up.
1. Remove tape and protective film from all surfaces
of unit.
2. Install the chip deflector inside, behind the upper
door. See Figure 5.
3. Install decals on the upper front and side stainless
steel panels.
Before installing decals, clean the stainless steel side
panels with a non-oily cleaner, such as isopropyl
alcohol (rubbing alcohol). After the cleaned surfaces
have dried, simply remove the protective backing
from the decal and apply to the panel. Any air
pockets or bubbles behind the decal can be removed
by rubbing gently with a soft cloth, working from
the center of the decal towards the outer edges.
WARNING
For safe and proper operation, the unit must be
located at a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
CAUTION
To prevent injury or damage the unit must be
transported in the upright position. If laid on its side,
all glass surfaces must be secured with tape.
CAUTION
Locate the unit at the proper counter height,
in an area that is convenient for use. The location
should be level to prevent the unit or its contents
from accidentally falling, and strong enough
to support the weight of the unit and food displayed.
CAUTION
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the ambient
air temperature is a minimum of 70°F (21°C).