Harbor Freight Tools 97181 - Manual (Page 13)

Page 13 For technical questions, please call 1-800-444-3353. Item 97181
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Troubleshooting
problem possible causes Likely Solutions
Belt/Disc Sander
does not turn on
1. Not plugged in.
2. No power at outlet.
3. Safety Key not inserted into Switch.
4. Switch is not turned “ON”. 1. Plug in Sander.
2. Check power at outlet and/or circuit breaker.
3. Insert Safety Key into Switch.
4. Turn on the Switch.
Motor slows
when sanding
1. V-Belt too tight.
2. Applying too much pressure
while sanding
1. Have the V-Belt adjusted by a qualified technician.
2. Use less pressure.
Wood burns
while sanding
1. Sanding disc or belt may be
loaded with dirt or debris.
2. Too much pressure.
1. Clean or replace disc or belt using
instructions in this manual.
2. Use less pressure.
Follow all safety precautions whenever diagnosing or servicing
the tool. Disconnect power supply before service.