Harbor Freight Tools CENTRAL PNEUMATIC 40131 - Manual (Page 3)

Page 3 For technical questions, please call 1-800-444-3353. Item 40131
4. Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that affects the tool's operation. If damaged,
have the tool serviced before using. Many accidents
are caused by poorly maintained hose reels.
There is a risk of bursting if the tool is damaged.
5. use only accessories that are identified by the
manufacturer for the specific tool model. Use of
an accessory not intended for use with the specific
tool model, increases the risk of injury to persons.
Service
1. Tool service must be performed only
by qualified repair personnel.
2. When servicing a tool, use only identical
replacement parts. use only authorized parts.
3. use only the lubricants supplied with the
tool or specified by the manufacturer.
air Source
1. never connect to an air source that is
capable of exceeding 200 psi.
Over pressurizing the tool may cause
bursting, abnormal operation, breakage
of the tool or serious injury to persons.
Use only clean, dry, regulated compressed air at the
rated pressure or within the rated pressure range as
marked on the tool. Always verify prior to using the
tool that the air source has been adjusted to the rated
air pressure or within the rated air-pressure range.
2. Never use oxygen, carbon dioxide, combustible
gases or any bottled gas as an air source
for the tool. Such gases are capable of
explosion and serious injury to persons.
Safety Symbol Definitions
Symbol Property or statement
PSi
Pounds per square inch of pressure
nPt
National pipe thread, tapered
WARNING marking
concerning Risk of Eye Injury.
Wear ANSI-approved eye protection.
Symbol Property or statement
WARNING marking concerning
Risk of Respiratory Injury. Wear
NIOSH-approved dust mask/respirator.
WARNING marking concerning
Risk of Explosion.
Specific Safety instructions
1. The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
2. Obey the manual for the air tool and air
compressor used with this tool.
3. Install an in-line shutoff valve to allow
immediate control over the air supply in an
emergency, even if a hose is ruptured.
4. WARNING: The brass components of
this product contain lead, a chemical
known to the State of California to cause
birth defects (or other reproductive harm).
(California Health & Safety code § 25249.5, et seq.)
Save theSe inStRuCtiOnS.
tool use and Care (cont.)
Sa
Fet
Y
O
Pe
R
ati
O
n
m
aintenan
C
e
Setu
P