Harbor Freight Tools 45813 - Manual (Page 6)

7. Avoid unintensional starting. Make sure you are prepared to begin work
before turning on the Polisher/Waxer.
8. Do not force the Polisher/Waxer. This tool will do the work better and safer at
the speed and capacity for which it was designed. Do not force the rotating Pad
(part #26) into the vehicle being waxed/polished. Apply moderate pressure,
allowing the Pad to rotate freely without being forced.
9. When waxing/polishing a vehicle, do not run the vehicle in an enclosed
area. Carbon monoxide is a colorless, odorless, vapor emitted from a vehicle’s
running engine that may cause severe injury or death if inhaled.
10. Never lay the Polisher/Waxer down until the Rotating Pad (part #20)
has come to a complete stop. The Rotating Pad can grab the surface and pull
the tool out of your control.
11. Make sure the vehicle being waxed/polished is free from burrs and any
other foreign matter which could damage the tool.
12. Never leave the Polisher/Waxer unattended when it is plugged into an
electrical outlet. Turn off the tool, and unplug it from its electrical outlet before
leaving.
13. Always unplug the Polisher/Waxer from its electrical outlet before perform-
ing and inspection, maintenance, or cleaning procedures.
14. WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known (to the State of Cali-
fornia) to cause cancer, birth defects or other reproductive harm. Some ex-
amples of these chemicals are: lead from lead-based paints, crystalline silica
from bricks and cement or other masonry products, arsenic and chromium from
chemically treated lumber. Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code 25249.5, et seq.)
15. WARNING! People with pacemakers should consult their physician(s)
before using this product. Operation of electrical equipment in close proximity to
a heart pacemaker could cause interference or failure of the pacemaker.
SKU 45813 PAGE 6