Harbor Freight Tools 45813 - Manual (Page 12)

SKU 45813 PAGE 12
17. Grip the Polisher/Waxer firmly with both hands. Then turn the Power Switch
(part #13) to its “ON” position and allow the Pad (part #26) to rotate to its fullest
speed. (See Figure D.)
18. Begin polishing the vehicle by lightly buffing off the wax residue in a circular
pattern. Continue polishing until all the wax residue is removed.
20. Remove the Polishing Bonnet (part #29) from the Pad (part #26). With the
Polishing Bonnet in your hand, remove the wax from all hard to reach areas
of the vehicle such as around lights, door handles, under bumpers, etc.
(See Figure D.)
19. After the wax has been removed from the vehicle’s surface, turn the Power
Switch (part #13) to its “OFF” position. Then unplug the Power Cord (part #14)
from the electrical extension cord, and unplug the extension cord from the
grounded, 120 volt, electrical outlet. (See Figure D.)
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Power Switch (part #13) of the Polisher/Waxer
is in its “OFF” position and that the tool is unplugged from its electrical outlet
before performing any inspection, maintenance, or cleaning procedures.
2. BEFORE EACH USE, inspect the general condition of the Waxer/Polisher.
Check for loose screws, misalignment or binding of moving parts, cracked or
broken parts, damaged electrical wiring, and any other condition that may affect
its safe operation. If abnormal noise or vibration occurs, have the problem cor-
rected before further use.
Do not use damaged equipment.
3. The most common error when waxing/polishing a vehicle is applying too much
wax. If the Pad (part #26) becomes saturated with wax, polishing will be more
difficult and will take longer. Applying too much wax may also reduce the life of
the Pad. If the Waxing Bonnet (part #28) continually comes off the Pad during
use, too much wax may have been applied.
4. Remove the Waxing/Polishing Bonnets (part #28, #29) from the Pad (part #26)
when the Waxer/Polisher is not in use. This will allow the Pad to dry and retain
its original shape.
5. To prolong Pad (part #26) life and shape, store the Waxer/Polisher with the Pad
face up.