Hilti TE3000-AVR - Manual (Page 9)

2.2 Chuck
28 mm hex. chuck
2.3 Switch
On / off switch
2.4 Grips
Grips incorporating AVR Active Vibration Reduction
2.5 Lubrication
Permanent lubrication with separate lubrication chambers for the gearing and hammering mechanism.
2.6 Theft protection system (optional)
The power tool may be equipped with the TPS Theft Protection System as an option. If the power tool
is equipped with this feature, it can be unlocked and made ready for operation only through use of the
corresponding TPS key.
2.7 Protective features
Protection from high temperatures is provided by the casing around inner parts of the power tool.
2.8 Indicator LED
Service indicator LED (see section “Care and maintenance”)
Theft protection system indicator (optional) (see section “Operation”)
2.9 Protection against overheating
The power tool is equipped with a protective overheating cut-out that switches the power off for a short time.
Overheating is indicated by an LED blinking.
2.10 Items supplied as standard
1 Power tool
1 Operating instructions with pocket for
attachment to the transport trolley
1 Transport trolley (optional)
1 Grease
2.11 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise lose performance and the extension cord may overheat. Check the extension
cord for damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section AWG12 AWG10
Mains voltage 110-120 V 75 ft 125 ft
Do not use extension cords with 16 AWG conductor cross section.
en
3